 |
|
-
Setup And Operating Instructions For
MM2-S Bar Stock Marker
Serial Number: 1526 and higher
-
- Unpack the machine and level using the level pads provided or secure to the floor. (Securing to the floor is optional)
- Screw out riggers to each side of the machine using dowel pins and bolts provided.
- Wire the machine and make sure the bottom shaft turns clockwise. A qualified electrician should do this.
NOTE: You are now ready to use the bar marking machine. With Machine Off
- Lower front guard.
- Remove jam nuts on upper and lower shaft and slide marking roll on bottom shaft; on top shaft you may use another marking roll or a blank support roll.
- Replace jam nuts.
- Place bar to be marked on outrigger to the left side of the machine.
- Adjust v-roller cradle by turning elevating screw so the bar rides on the lower marking wheel.
- Lock the elevating screw by using the lock nut on the shaft of the elevating screw.
- Adjust the guide rollers to keep the bar to be marked centered between rolls and lock in place by tightening the shoulder screws.
- Lower top wheel until it touches the bar by turning the hand wheel on the top of the machine.
- Remove the bar from between the rolls.
- Turn hand wheel clock wise one full turn.
- Return front cover to up position and lock. (DO NOT OPEN FRONT COVER WHILE THE MACHINE IS RUNNING)
- Turn on machine.
- Push bar between v-roller and guide rolls and allow the marking rolls to pull the bar through the machine.
- Retrieve bar from the right side of the machine and inspect the markings.
- If a deeper mark is required, turn hand wheel clockwise until the proper mark is obtained.
At operating position the machine noise level does not exceed 7OdB(A). NOTE: Larger and more marking nomenclature will require more pressure to mark. Care Of Machine Lubrication of machine should be done once a week.
- Shafts: Grease four zirks, located on the right side of the machine using Amoco Super Permalube Cn-mw.
- CTtw Case: Remove front cover of lower cabinet to expose the gear drive. Check the gear oil in accordance with Boston Gear specifications provided.
|
|
|
|
|
|
286 Spires Parkway
Tekonsha,
MI
49092
Phone: 517-767-4155
Fax: 517-767-3325
HOURS:
Monday - Friday
8:00 AM - 4:30 PM
|
|
